Softener control valve replacement in Millcreek UT can save you the cost of a whole new system. The control valve sits on top of the tank and runs everything. It decides when to regenerate and moves water through backwash, brine and rinse. When it wears out, the softener stops doing its job and hard water comes back. If your tanks and resin are still good, a new valve can get you soft water again.
When You Need Softener Control Valve Replacement
Signs of a failing valve include a softener that won't regenerate, one that regenerates at the wrong times, water leaking from the valve head, a display that's blank or showing errors, or settings that reset after every power flicker. Salt that never goes down in the brine tank is another clue.
Common causes are worn seals and discs, a failed motor, and old electronics. Hard water and sediment speed up the wear. If you wait, the softener keeps letting hard water through, and a leak at the valve can get worse.
Before replacing the valve, it's worth checking a few easy things. Make sure there's salt in the brine tank, the bypass is set to service, the valve is plugged in, and the time of day is set right. If those all check out and the softener still isn't working, the valve is a likely suspect.
Modern programmable valves are easier to set up, and the ones we install keep their settings through power outages for up to 72 hours.
Our Softener Control Valve Replacement Process
We start by checking the whole system to confirm the valve is the problem and not the brine line, injector or salt. If the valve needs replacing, we match a new one to your tank size and plumbing. We supply common valves, including the Clack WS1, and the programmable ceramic-disc valves used on the systems we install.
We shut the water off at the bypass, swap the valve, check the seals, and program it for your hardness and household size. Then we run a regeneration to make sure every step works.
A new valve can also be a chance to fine-tune your system. We set regeneration based on your actual hardness and household size, which can save salt and water compared to how the old valve was set.
If the bypass is cracked or stiff, we'll recommend replacing it at the same time, since it's easy to do while the system is already open.
Softener Control Valve Replacement Cost in Millcreek
Price depends on the valve model your tank needs and whether the bypass or other fittings need replacing at the same time. We'll show you what's worn, give you the price before we start, and tell you honestly if a full replacement makes more sense for an older system.
If your softener is very old and the resin is worn out, putting a new valve on it may not be worth it. We'll test the water after regeneration to see how well the resin is working before you decide.
Why Choose Us
We're open 24 hours a day, 7 days a week, and we respond in about 10 minutes on average. We're an authorized dealer for the equipment we install, so the team that sells it is the team that installs and services it. We're Utah locals with offices in Millcreek and Draper, covering everywhere from Bountiful to Orem. We supply the valves and parts for the systems we install.
We'll leave the valve set up for your water and show you the basics.
Not sure it's the valve? See our full water softener repair service.